Quest-diagnostics QUESTEMP 36 Uživatelský manuál

QUESTemp° 36 Thermal Environment Monitor Operator’s Manual Note: Due to the new ATEX Directive in Europe, all references in this document to

19battery. If the rechargeable battery pack ever needs to be replaced, it can be accessed by removing the screws from the bottom panel of the unit.

21Remote Sensor Bars: 2 x 15pin D-sub jacks are located on the side of the unit for plugging in 1 or 2 additional sensor bars by using remote cables

23ACGIH CLOTHING CORRECTIONS The following clothing corrections are in degrees Celsius. When a clothing correction is entered into the setup portio

25 ELECTRICAL POWER RESEARCH INSTITUTE The recommended working hours are shown based on a maximum of four hours. A time of 4:01 indicates greater

2718. QUEST SERVICE AND WARRANTY POLICY Service Information Congratulations! You have purchased one of the finest instruments available, manufactu

3TABLE OF CONTENTS 1. UP AND RUNNING... 5 2. USING THE QUESTEMP...

51. UP AND RUNNING 1. Make sure the wet bulb’s wick is clean. Fill the reservoir with distilled water. 2. Place the QUESTemp in the work area

7The Heat Index is defined over a temperature range of 70°F - 120°F (21°C - 49°C) and a relative humidity range of 30% - 99%. Outside of this range,

9PRINT Allows printing to a parallel or serial printer or to a computer. The unit will recognize the cable plugged in and configure itself for seria

11 A series of dashes appear in the display if one of the following occur: • the Heat Index or Humidex is outside of its allowable range • the temper

13SAMPLE PRINTOUT QUEST TECHNOLOGIES Page 1 HEAT STRESS REPORT File Name

159. PC COMMUNICATIONS The QUESTemp°36 has the flexibility to be set up and controlled through computer software. The programmable start and stop

17 OPERATING SEQUENCE 1. Turn FLOW ON in the setup menu of the Questemp°36. 2. Plug the Air Probe into the port labeled FLOW on the side of the Que